Isopropyl alcohol or ipa solution can remove all the remaining contaminants present on the paint.
Isopropyl alcohol wipre before ceramic coat.
However i would wipe the powder off only to see more and more upon repeating the ipa wipedown 3 4 times.
You ll need several microfiber towels to dry polish and wipe off the ipa.
And perfecting the paint before im ready to apply ceramic coat.
The last item to complete is the ipa spray.
Ipa or isopropyl alcohol wipe.
This will remove all the residue of the clay bar treatment any excess polish or wax so the surface is perfectly clean.
Pearl nano decon ceramic coating prep spray is the perfect coating prep cleaner for removing polish oil residue grease and old waxes from all surfaces.
Isopropyl alcohol works to break down these oils and other surface contaminants and leaves a completely clean area to apply the ceramic coating.
Always use fresh and clean microfiber towels with each step to avoid.
After polishing each panel i was sure to wipe off the excess polishing compound off with a clean microfiber.
However when i go to do the ipa wipedown with 70 ipa i keep on getting excessive white powdery residue after the alcohol dries.
Pearl nano decon ceramic coating prep spray is a combination of mild solvents that dissolves and removes all wax and oil.
Polishes and cutting compounds contain carrier oils that allow the material to grasp onto the surface.
If this step isn t executed properly all the hard work and efforts you ve previously performed can all go to waste.
If concerned about your current clear coat levels check out this video on youtube for tips on measuring it.
It makes your car look like a new vehicle.
So make sure you don t keep your vehicle waiting for too long after finishing the pre coating tasks.
Polishing and paint correction deal with swirls fine scratches and paint imperfections prior to applying the ceramic coating.
Be sure to use this before applying ceramic coatings or waxes.
Purchase a spray bottle and distilled water to use with the alcohol.
In general thousands of people use isopropyl alcohol in some way or another although there are some that prefer not to ever use it on paint.
The last step before the ceramic coating process is a thorough wipe with an ipa iso propyl alcohol based solution to remove any existing residues or surface contaminants left behind during the polishing process.
But without coating the vehicle it ll easily get ruined again.
A diluted isopropyl alcohol solution has been shown to be the best option in this case.
November 1 2019 at 6 31 pm.
If this step isn t executed properly all the hard work and efforts you ve previously performed can all go to waste.
Wipe down with ipa solution diluted isopropyl alcohol this final wipe down is necessary to remove any waxes or oils that may remain on the surface so that the ceramic coating will adhere properly.
